DM9010
The DM9010 is a 10/100M fast Ethernet local bus network controller. It is designed with low power and high performance process that support 3.3V with 5V IO toleranc
100-pin LQFP
Supports processor interface: Byte/word/Dword of I/O command to internal memory data operation
Integrated 10/100M transceiver with HP Auto-MDIX
Supports MII and reverses MII interface
Supports back pressure mode for half-duplex mode flow control
IEEE802.3x flow control for full-duplex mode
Supports wakeup frame, link status change and magic packet events for remote wake up
Integrated 16K Byte SRAM
Build in 3.3V to 2.5V regulator
Supports early Transmit
Supports IP/TCP/UDP checksum generation and checking
Supports automatically load vendor ID and product ID from EEPROM
Supports 7 or 23 GPIO pins
Optional EEPROM configuration
Very low power consumption mode:
- Power reduced mode (cable detection)
- Power down mode
- Selectable TX drivers for 1:1 or 1.25:1 transformers for additional power reduction
-Lan Transformer 100Base-TX and 10Base-TX YL2J201A or YT18-2601S or 16YM001
- 1: 1 transformers only when HP Auto-MDIX Enable
Compatible with 3.3V and 5.0V tolerant I/O
DM9010+YT37-1107S+RJ45
DM9010+YT18-2601S+RJ45
DM9010+YL2J201A
DM9010+16YM001+RJ45
DM9010+YL2J011D
